Harbor Board Sneakers

Men’s board sneakers cut from smooth leather in a low-top shape, built on a flat white cupsole. The vamp is unbroken leather with a short five-eyelet lace front, so the pair reads clean rather than busy, and the collar and tongue are padded for the ankle and instep. A heel pull loop makes them easy to pull on without creasing the counter.

Men’s Board Sneakers: Sole, Fit and Finish

The rubber cupsole runs the length of the foot with a textured sidewall and a low-profile tread, so the pair sits flat on pavement, in the office or at a café table. Stitching runs along the quarters and around the toe, and the leather is burnished at the edges for a slightly worn-in look. Inside, a cushioned insole takes the first hit from hard floors.

Build and Colours

• Upper: smooth leather with burnished edges
• Lining: soft textile lining
• Closure: five-eyelet lace front with flat waxed laces
• Collar: padded, with a heel pull loop
• Outsole: white rubber cupsole with a low tread
• Colours in this batch: brown and black
• EU sizes in this batch: 39, 40, 41, 42, 43, 44

Fit and Sizing

The supplier gives a foot-length table with this model: EU 39 for 245 mm, 40 for 250 mm, 41 for 255 mm, 42 for 260 mm, 43 for 265 mm and 44 for 270 mm, with a stated measuring tolerance of about 5 mm. Measure your foot flat against a wall and pick the length that matches, and take your usual EU size if you are between two. The lace front lets you set the fit across the instep.

Care

Wipe the leather with a soft damp cloth, let it dry away from direct heat, and use a neutral leather cream when the surface starts to look dry. Do not machine wash and do not tumble dry.